Dyno Results

[HERS351]

Have any of you with 95 S351'S N/A had you cars Dyno'd. I just did, and it was not even close to the production numbers. The car only has 17K miles on it and is completely stock. My numbers were 266hp/328torque. Just wondering if this is in line with anyone else's??

[Saleen1]

My car is completely stock (except for off road x pipe), but it is an R code, it only makes 6 lbs of boost. It made 369 hp and 440 torque to the wheels. My car was PIG rich at 9.8 to 1 air fuel ration though, so it is only a tune and a pully away from well over 400 to the wheels.....

I would have thought a na car would have made between 280 and 300 to the wheels....., so you are not too far off. Change out the h pipe. My stock cats were VERY restrictive, and very beat up from hitting all the time becuase of how low the 1994s sit (saleen raised the 95's 1 inch higher to try and avois some of this).

[HERS351]

For now I am going to leave it alone. Trying to leave it stock. But yes the four cats are restictive. Considered putting a vortech polished s-trim on it so it would look stock, but not will to cut on car right now. It does sit low, both my husband and I have earlier model 95's before they switched to the higher springs, but car was well maintained before I got it so cats :) are in good shape. Will just have to accept it being alittle slower for now, and just looking goooood!!