PDA

View Full Version : rear louvers

48prerunner
04-06-2009, 06:39 PM
Anybody have a picture or know the size of the studs and nuts that hold the rear louver on?
SCMcQueen
04-06-2009, 06:50 PM
The service manual is posted somewhere on the forum. I just checked it (I always download installation/service manuals) and it does have pictures but no size/dimensions. You should be able to find it if not let me know and I will figure out where I got it. I have a Heritage with the same louvers. I also ran into a guy that works at the company that makes them (CPS, in Michigan).
SCMcQueen
04-06-2009, 06:55 PM
I found it..go to Saleen Enthusiast Forums; then SOEC members only; it is Saleen Technical Bulletins and it is the installation manual. Hope it helps. Mine is in storage or I would measure them for you.
48prerunner
04-06-2009, 09:07 PM
I found it..go to Saleen Enthusiast Forums; then SOEC members only; it is Saleen Technical Bulletins and it is the installation manual. Hope it helps. Mine is in storage or I would measure them for you.

I have that manual doesnt state the size or show the stud but thanks for offering. Its just gotten "warm" enough here to take mine out well not so much warm but no snow on the ground as of now.
48prerunner
04-11-2009, 04:08 PM
I found it..go to Saleen Enthusiast Forums; then SOEC members only; it is Saleen Technical Bulletins and it is the installation manual. Hope it helps. Mine is in storage or I would measure them for you.

I need to look if there is an install for oil and water temp gauges but i must be missing something I cant find the SOEC members only?
Jim D.
04-11-2009, 05:44 PM
I need to look if there is an install for oil and water temp gauges but i must be missing something I cant find the SOEC members only?

If your SOEC membership is not tied to your forums registration, you will not see the Members Only forum.

But last week I already e-mailed you the only instructions we have.
48prerunner
04-12-2009, 08:15 AM
If your SOEC membership is not tied to your forums registration, you will not see the Members Only forum.

But last week I already e-mailed you the only instructions we have.

Yes thank you I got the instructions on the louvers they are great and i figured out what was going on with the members only section, found the instructions for the gauge pod.