|
Register | FAQ | Members List | Calendar | Mark Forums Read |
2008-2009 Racecraft Mustang For discussion of the 2008-09 Racecraft 420S Mustang. Owners of the 2007-08 "Sleeper GT" can also find help here. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Q's: Gear ratio & boost? - Series VI SuperShaker
I have the 2008 420s ford racecraft with the added shaker rated at 485 hp I am considering upgrading the rear gear ratio to a 3.73 I am assuming it is currently 3.55 equipped on 5 speed manual transmission also would like to raise the boost has anyone performed this what did you use I don't think I would go above 8 any Ideas please
|
#2
|
|||
|
|||
Upgrades
I went a little too far with my upgrades: I took my 2008 420S to JDM and had their Stage 3 kit installed and dyno tuned, link here:
http://www.teamjdm.com/2005-2010-sal...-3-kit-by-jdm/ It's awesome! And I like to drive it HARD (some people don't really) and took it to Summit Point four times before I finally threw a couple rods. Here's the link, go the end and you'll understand. https://www.youtube.com/watch?v=NeqLYmgMMCc&t=759s Not JDM's fault, I drove it too hard. So I put in a forged shortblock and I'm in the process of doing some suspension mods. It's a lot of fun. My advice is play it safe if your car is a daily driver or just a street car. But if you want something fun, she can be that too. You just need to have a solid plan for the car when you start. Just my 2 cents. Oh, I can't wait to go back. Now she's got a torque arm, coilovers, T56, and lots more... |
#3
|
||||
|
||||
Quote:
|
#4
|
|||
|
|||
Quote:
__________________
Terminator powered foxbody https://www.youtube.com/watch?v=92hxg7Bg-5Y Sold xp8 2000 #30, all options including alcons |
#5
|
|||
|
|||
Dyno sheet
Here's the dyno sheet from JDM before I threw some rods. They did this one on the dyno. I have a canned tuned from the them now for the new motor, looking to back in the spring.
Some people may not be a fan of changing rear gears, I think it's important that the gears match the other components in the car. I my case I swapped in a T56 Magnum with a lightened flywheel. Even with the wider ratio gear set, I needed 3.73's to get her moving gracefully. Lots of fun modding these cars and lots to learn. Enjoy... |
#6
|
||||
|
||||
Quote:
|
#7
|
|||
|
|||
Lean?
The way Jim at JDM explained it to me was that 11.0:1 was the goal, and a few tenths over was fine. Too close to 10.5 is a little rich and above 11.5 is a little lean, which means hotter and heat is enemy of blowers.
She has great throttle response and ran fine until a few rods just got tired and quit. My bad for running so much boost on a stock bottom end. It's probably not too bad on the street, but at the track (HPDE, not real wheel to wheel) where one just hammers it for 10 minutes at a time it really shows the weak points... Last edited by cgornowich; 03-23-2018 at 05:26 PM. |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|