|
Register | FAQ | Members List | Calendar | Mark Forums Read |
2007 Saleen/Parnelli Jones Limited Edition Or as Parnelli likes to call them, for "the Parnelli Jones/Saleen Limited Edition." |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
How to: PJ center cap clean-up attempt
Hi All
Mine have fine surface fractures from what it looks like. Since these are not yet available, or never will be available, I decided to try and "polish" the clear resin, polyurathane, acrylic, whatever it may be ect... So what I did was use a Dremel tool first first with a polishing compound. Mistake!!! The heat generated melted the clear cover ever so slightly. Even at low rpm with light pressure. The clear is soft. After masking the entire silver section of the cap, I decided to wet sand by hand. Using 400 grit wet sand paper, I started to see a change in the clear water to a whitish look. This was easily removing the aged clear surface. After the 400 wet sanding, I went to 1200 wet sand. Then a hand, no wax hand polishing compound used by show cars to remove swirls. Although the results are not "like new", they are still much better than the frosted look of the plastic. The part that is still a challenge is the edge near the silver cap where the plastic meets the silver cap. It is very difficult to sand there and not remove silver. I have before pics, but if you have this problem, you don't need pic of the before. Excuse the poor quality pic. Steve |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|