|
Register | FAQ | Members List | Calendar | Mark Forums Read |
1994-1998 Saleen Mustang For the SN-95 platform. Be sure to specify year, model and equipment if asking for help. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Q: SN95 Graphics Locations
98-104 is getting a complete repaint and I have received all of the correct graphics through Molly @ Saleen. Would anyone have the measurements for a correct install? I have found them for the New Edge cars just not the SN95's. Could anyone help with this?
If not I have been gathering lots of photos of various SN95 cars in hopes to get things as close as possible. Thanks, -Daniel
__________________
95-039 S351 vert 98-104 S281 Cobra coupe |
#2
|
|||
|
|||
Sorry for the late response. I don't check forums too often anymore.
I do remember that the stripes are aligned with the door to fender gap. The top of the rear stripe is centered wit the gap. The angle is dictated by the top body line. I think I have a measurement for the letter at home if you are still looking. |
#3
|
||||
|
||||
Justfloatn,
Yes, I am still looking. Thank you for the response. The car should be ready to install the graphics by early next week. Anything you have would be a great help. -Daniel
__________________
95-039 S351 vert 98-104 S281 Cobra coupe |
#4
|
|||
|
|||
These should help. So the center of the front stripe starts at the front edge of the door. The script is 11" from the back edge of the door. Don't worry about being off by 1/8" or so either way. I doubt two of these left the factory the same way.
|
#5
|
||||
|
||||
Justfloatn,
THANK YOU SO MUCH! I have been looking everywhere for this. From the looks of things the chevrons at roughly an inch apart? Maybe a few mm less? -Daniel
__________________
95-039 S351 vert 98-104 S281 Cobra coupe |
#6
|
|||
|
|||
I forgot about that part. I believe they are 1" apart. I'll check on Monday. I'm keeping the car at my shop right now.
|
#7
|
|||
|
|||
Depending on how you measure. If I measure parallel to the ground following the top edge I get 1.1/8". If I measure the distance perpendicularly between the stripes I get slightly under 7/8".
It's Pythagorean theorem angles. |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|