[jrcalvin]

The Saleen Supershaker Kit has a "trim template" pattern for the Supershaker hood cutout and notes very, very slight cutout position difference between stock 2005-2009 GT Mustang hood and Saleen 2005-2009 S281SC vented hood.

1. Question does anyone have the Saleen "Trim Template" pattern, noted in Saleen install instructions, available from an older Supershaker installation? Available to sell, rent or whatever?

2. Perhaps a Saleen Supershaker owner with a Saleen SC vented hood could measure the distance from rear hood center to aft inside edge of plastic trim? Also measure distance from sides of hood to inside edge of plastic trim left side and right side?

3. If cutting a Saleen S181SC hood with vents....measure 3 times and cut only once? Any help to cut only once correctly, accurately would be very much appreciated!

4. CDC has a hood scoop cutout pattern but there is no guarantee that the CDC hood scoop pattern is in the "exact" same location as the Saleen Supershaker hood scoop cutout. As I noted, the location and pattern must be accurate/precisely located.