View Single Post
  #3  
Old 11-04-2009
2007SaleenS331's Avatar
2007SaleenS331 2007SaleenS331 is offline
SOEC Member
 
Join Date: Nov 2008
Location: Billings,MT
Posts: 124
Default

Quote:
Originally Posted by belgamo View Post
Finally getting this issue taken care of, wondering if anyone has any info on the correct angle that we should be looking at.

Would like to beable to give the guy some information. thanks
Your dealing with a 2 piece driveshaft, so you would have to measure off the front shaft and the pinion flange. I had to put a 3 degree shim to angle the pinion down to get the correct angles. I went to www.wolferacecraft.com to get a better understanding of setting the correct driveshaft angles. I got rid of my driveline vibration using this info.
Reply With Quote